daily_automated

trunk/Arduino/libraries/IRremote/examples/IRsendDemo/IRsendDemo.ino

@@ -0,0 +1,48 @@
+/*
+ * IRremote: IRsendDemo - demonstrates sending IR codes with IRsend
+ * An IR LED must be connected to Arduino PWM pin 3.
+ * Version 0.1 July, 2009
+ * Copyright 2009 Ken Shirriff
+ * http://arcfn.com
+ */
+
+#include <IRremote.h>
+
+IRsend IrSender;
+
+// On the Zero and others we switch explicitly to SerialUSB
+#if defined(ARDUINO_ARCH_SAMD)
+#define Serial SerialUSB
+#endif
+
+void setup() {
+    pinMode(LED_BUILTIN, OUTPUT);
+
+    Serial.begin(115200);
+#if defined(__AVR_ATmega32U4__) || defined(SERIAL_USB) || defined(SERIAL_PORT_USBVIRTUAL)
+    delay(2000); // To be able to connect Serial monitor after reset and before first printout
+#endif
+    // Just to know which program is running on my Arduino
+    Serial.println(F("START " __FILE__ " from " __DATE__));
+    Serial.print(F("Ready to send IR signals at pin "));
+    Serial.println(IR_SEND_PIN);
+}
+
+void loop() {
+    unsigned long tData = 0xa90;
+    for (int i = 0; i < 3; i++) {
+        IrSender.sendSony(tData, 12);
+        Serial.print(F("sendSony(0x"));
+        Serial.print(tData,HEX);
+        Serial.println(F(", 12)"));
+//        IrSender.sendJVC(0xC5B8, 16,0); // hex value, 16 bits, no repeat
+//        delayMicroseconds(50); // see http://www.sbprojects.com/knowledge/ir/jvc.php for information
+//        IrSender.sendJVC(0xC5B8, 16,1); // hex value, 16 bits, repeat
+//        Serial.println(F("sendJVC(9xC5B8, 16)"));
+
+        delay(40);
+    }
+
+    tData++;
+    delay(5000); //5 second delay between each signal burst
+}