daily_automated

trunk/Arduino/libraries/ArduinoOTA/examples/SerialWiFiOTA/SerialWiFiOTA.ino

@@ -0,0 +1,74 @@
+/*
+
+ This example polls for sketch updates over WiFi module on Serial1,
+ sketches can be updated by selecting a network port from within
+ the Arduino IDE: Tools -> Port -> Network Ports ...
+
+ created 13 July 2010
+ by dlf (Metodo2 srl)
+ modified 31 May 2012
+ by Tom Igoe
+ modified 16 January 2017
+ by Sandeep Mistry
+ Serial WiFi version December 2019
+ by Juraj Andrassy
+ */
+
+#include <WiFiEspAT.h>
+#include <ArduinoOTA.h>
+
+void setup() {
+
+  Serial.begin(115200);
+  while (!Serial);
+
+  // initialize Serial1 for communication with the WiFi module
+  Serial1.begin(115200);
+  WiFi.init(&Serial1);
+
+  if (WiFi.status() == WL_NO_SHIELD) {
+    Serial.println();
+    Serial.println("Communication with WiFi module failed!");
+    // don't continue
+    while (true);
+  }
+
+  // waiting for connection to Wifi network with settings in the WiFi module
+  Serial.println("Waiting for connection to WiFi");
+  while (WiFi.status() != WL_CONNECTED) {
+    delay(1000);
+    Serial.print('.');
+  }
+  Serial.println();
+  Serial.println("Connected to WiFi network.");
+
+  // start the WiFi OTA library with internal (flash) based storage
+  ArduinoOTA.begin(WiFi.localIP(), "Arduino", "password", InternalStorage);
+
+  // you're connected now, so print out the status:
+  printWifiStatus();
+}
+
+void loop() {
+  // check for WiFi OTA updates
+  ArduinoOTA.poll();
+
+  // add your normal loop code below ...
+}
+
+void printWifiStatus() {
+  // print the SSID of the network you're attached to:
+  Serial.print("SSID: ");
+  Serial.println(WiFi.SSID());
+
+  // print your WiFi shield's IP address:
+  IPAddress ip = WiFi.localIP();
+  Serial.print("IP Address: ");
+  Serial.println(ip);
+
+  // print the received signal strength:
+  long rssi = WiFi.RSSI();
+  Serial.print("signal strength (RSSI):");
+  Serial.print(rssi);
+  Serial.println(" dBm");
+}