trunk/Arduino/libraries/DallasTemperature/examples/Simple/Simple.ino

@@ -8,7 +8,7 @@
 // Setup a oneWire instance to communicate with any OneWire devices (not just Maxim/Dallas temperature ICs)
 OneWire oneWire(ONE_WIRE_BUS);
 
-// Pass our oneWire reference to Dallas Temperature. 
+// Pass our oneWire reference to Dallas Temperature.
 DallasTemperature sensors(&oneWire);
 
 /*
@@ -28,22 +28,23 @@ void setup(void)
  * Main function, get and show the temperature
  */
 void loop(void)
-{ 
-  // call sensors.requestTemperatures() to issue a global temperature 
+{
+  // call sensors.requestTemperatures() to issue a global temperature
   // request to all devices on the bus
   Serial.print("Requesting temperatures...");
   sensors.requestTemperatures(); // Send the command to get temperatures
   Serial.println("DONE");
+  delay(1500);
   // After we got the temperatures, we can print them here.
   // We use the function ByIndex, and as an example get the temperature from the first sensor only.
   float tempC = sensors.getTempCByIndex(0);
 
   // Check if reading was successful
-  if(tempC != DEVICE_DISCONNECTED_C) 
+  if (tempC != DEVICE_DISCONNECTED_C)
   {
     Serial.print("Temperature for the device 1 (index 0) is: ");
     Serial.println(tempC);
-  } 
+  }
   else
   {
     Serial.println("Error: Could not read temperature data");